DirectSoft 5 Modbus

[Landmarc]

Hey im using the directsoft 5 software for a DL06 PLC. Im pulling signals in from the modbus port 2 from a slave third party device. Im having problems with my registers, Im taking decimal numbers off the correct holding regisers on the slave but im not getting any information transfered to my v2100 registers that iv selected to hold the information on the PLC. The PLC is communicating with the slaves but not getting the information into the registers. Iv been troubleshooting this for a couple days now but im out of ideas. Iv attached my program if anyone has any input.


Thanks

 

[Landmarc]

Correction

I was looking at the wrong v memory locations. I am now reading the correct registers and im getting the correct information. The problem im having now is i have a FO-08DAH-1 analog current output module in slot 1 of the PLC but im not reading any output current.

 

[bernie_carlton]

You have an analog module setup to send its data into the same registers (V2100 and up) that the Modbus communication is using.