Dear Dox 10 Gurus,
I actually have very limited knowledge about dox 10 and I d like to
consult you about attached error.
I have a program and I try to add a flow pulse reading.
PM 16 is the fast loop and I can adjust its scan time around 100 ms.
well the flow meter pulse width is about 200 ms.
but the problem is I could not translate the project after I did attached small rung
NOte: I tried reset global falgs but did not help
I d appreciate if any dox guru can help.
best regards
Volkan
I actually have very limited knowledge about dox 10 and I d like to
consult you about attached error.
I have a program and I try to add a flow pulse reading.
PM 16 is the fast loop and I can adjust its scan time around 100 ms.
well the flow meter pulse width is about 200 ms.
but the problem is I could not translate the project after I did attached small rung
NOte: I tried reset global falgs but did not help
I d appreciate if any dox guru can help.
best regards
Volkan
Last edited: