FactoryTalk View data logging in file set format

[Syedghouse]

Hello all,
Data logging in factoryTalk view has stopped suddenly, i cannot able to find the reason.
Then i tried creating new datalog models but still i am not getting the data logged file.
Please help me with it.

 

[woolie161]

I have had this happen a couple of times and through "trial & error" I have resolved the issue. There could be various reasons why this happens.
Below is a selection of things I have done to get data logging recording again.
1) Power Cycle the unit.
2) Remove the CF / SD card (depending on model), allow logging without card.
then re-insert the card and from setup mode, format the card.
Re-start the unit.
3) Delete Data Logging from the project, download & run project. Re-instate
Data Logging, download and run project.

I don't think Rockwell will have these listed as "fix" functions, but they have worked for me on several occasions.

I hope this helps

 

[Operaghost]

Are you using FactoryTalk View ME (like with a PanelView terminal), or are you using FactoryTalk View SE?

Woolie's response would apply to ME, but not necessarily to SE.

OG

 

[woolie161]

Are you using FactoryTalk View ME (like with a PanelView terminal), or are you using FactoryTalk View SE?

Woolie's response would apply to ME, but not necessarily to SE.

OG

Operaghost is correct, I made the assumption it was ME as I haven't had that issue with SE. Silly me to assume.

Woolie