I don't know much and I'm just getting involved in this world. I want to turn this into a learning experience than just replacing things
As a learning project I'm playing with a small conveyor, run by relay's. I have a Click PLC C0-00DR-D, and a Rhino power supply (apparently it's a switching type).
I was getting some feedback from the relay's when they closed that was preventing communication and was trying to put in a snub diode to see if that solved my problem.
I didn't do it right and got some sparks (yes, I should have turned/unplugged things before doing it, I was stupid).
All the lights died on both the power supply and PLC. My dad who is a electrical engineer, said to check the fuse on the power supply. The Fuse is fine.
How do I fix this?
What can I learn from this? (besides fixing things with the power on)
As a learning project I'm playing with a small conveyor, run by relay's. I have a Click PLC C0-00DR-D, and a Rhino power supply (apparently it's a switching type).
I was getting some feedback from the relay's when they closed that was preventing communication and was trying to put in a snub diode to see if that solved my problem.
I didn't do it right and got some sparks (yes, I should have turned/unplugged things before doing it, I was stupid).
All the lights died on both the power supply and PLC. My dad who is a electrical engineer, said to check the fuse on the power supply. The Fuse is fine.
How do I fix this?
What can I learn from this? (besides fixing things with the power on)