Ge fanuc and lenze servo

[Ken Riley]

I need help in wiring a Lenze servo motor to a GE Fanuc 90-30 controller.
I am using a DSM314 module...
The Lenze servo is a compact servo motor 15513996
Motor MCS 09F60LRS0P1

 

[RussB]

GFK-1742 from the GEIP support web site will answer all of your questions.

 

[Steve Bailey]

It's more than simply wiring. There will parameters you need to set in hardware configuration for the DSM314.

At minimum, you will need connections for the drive enable and drive run commands from the DSM314 to the drive, the drive OK signal from the drive to the DSM314, the +/- 10 VDC analog speed reference from the DSM314 to the drive, and the encoder pulses from the drive to the DSM314.