GS1 drive controlled with Master K 120S MODBUS channel

alendi

Member
A
Join Date
Aug 2005
Location
San Casimiro, Aragua
Posts
36
Hi Friends
Here in a new project, I'll need to control a GS1 drive from Automation Direct using a Master K120S PLC MODBUS connection, is it possible? and how can program it?
Is needed an special connection wire?
The function will be soft start to full RPM, in 10 sec the RPM will begin to 0 in 4 seconds, got it?
Thanks for help:site:
 

Similar Topics

R
Unable to control the GS1 drive from DL06
Hi, I'm trying to send write (MWX) commands from DL06 for frequency and start/stop control of a motor connected to a GS1 Drive. The GS1 Drive...
Replies
1
Views
1,533
gclshortt
gclshortt
L
AD GS1 Drive to a DL-06
Does anyone know what cable you use for this and since it takes up Port 2 how could you run a Display also. I saw the FA-ISOCON but how does that...
Replies
7
Views
3,092
bernie_carlton
bernie_carlton
Z
AD GS1 Drive Problems
We are using an AutomationDirect GS1-10P5 1/2hp drive that takes 120vac input and outputs 230vac 3ph. We have one customer that says the drive had...
Replies
0
Views
3,152
zmanvortex
Z
Eric Nelson
GS1 Drive Max Speed...
I asked this question over at the A-D forum, but the response time 'round here is much better... :cool: When using the front panel potentiometer...
Replies
9
Views
5,452
Eric Nelson
Eric Nelson
xzen
Barcode GS1-128 (UCC/EAN-128)
I have a scanner that reads barcode GS1-128. The reading is presented in a SIMATIC S7 PLC as one long string in a DB (DB15 in example). I need to...
Replies
11
Views
5,155
longwest
L
Back
Top Bottom