LMDAVE
Member
I was tasked with updating a 2001 computer that was running FIX 7.0 to a newer 2009 Dell. I installed all the same versions of software and everything is working great except for one thing, when I plug the blue parellel software key into the new Dell, it says I don't have a key. I powered down and pulled it back out and put it in the old computer and it works so I know I didn't damage it.
Some info:
The key in the old computer won't let me go to draw mode, or database view, it says key is not licensed for that. But the key says Full Scada. Either way, in the new dell it just doesn't recognize the key at all.
The parallel port is working, I have a printed installed in the back of the new computer through the key and it printed fine.
Any ideas why this is happening? I only had today available to get this thing running.
Some info:
The key in the old computer won't let me go to draw mode, or database view, it says key is not licensed for that. But the key says Full Scada. Either way, in the new dell it just doesn't recognize the key at all.
The parallel port is working, I have a printed installed in the back of the new computer through the key and it printed fine.
Any ideas why this is happening? I only had today available to get this thing running.