Help with Mitsu A1SH comm

[panic mode]

how exactly did you test it? did you test it on a
real serial port? are there any errors on the card?
what are the plc parameter settings for this card etc.?
which manuals you use?

 

[Dariusch]

Ok Now it is up running, thank you all.


The cable used =

UC24 N-Port
Pin 2 -------- 3
3 -------- 2
5 -------- 5
1--| |--1
4--| |--4
6--| |--6
7-| |-7
8-| |-8

Crossing pin 2 and 3.
Pin 5 straight through
connect pin 1,4 and 6 together
connect pin 7 and 8 together.

But I also have to use the "Nulmoden" adapter that came with the N-port.

The protocol is as satatet earlier.

I have not tried your connection after this panic, because i had only 2 sets of SUB-D9.

Thank you for the help...


Dariusch

 

[Dariusch]

Hi Panic, your post came at the same time I stated my.

Yes at last I tested the other cable direct with a real COM (COM1)
But after I had it up running I was would not do any more soldering. Had done soldering all day with all kinds of connections


But I owe you Panic and I for your knowledge.

Thaks again

Dariusch