Hi PLC Wizards!
I am new with PLC. And currently I'm having a problem with uploading/downloding of my HMI program. We are using quickpanel jr. 10.5" and using quickdesigner software version 3.7. And using HMI-CAB-C49/G prorgramming cable. When I am uploading/downloading my HMI program to the quickpanel jr. device, in the message column will tell me " device not ready " and eventually will prompt " device hung ". I tried to shutoff the quickpanel jr. power. The message column will prompt " device off ---> turn on power ". When I turn on the power back, I will be prompted again with " device not ready ". I pretty sure that my programming software and cable is fine since I can do the uploading/downloading with another device.
I hope I am asking the right forum and hoping someone out there can help me with my problem.What could be the possible causes and possible solutions ( if there is any )?
Thanks and best regards!
I am new with PLC. And currently I'm having a problem with uploading/downloding of my HMI program. We are using quickpanel jr. 10.5" and using quickdesigner software version 3.7. And using HMI-CAB-C49/G prorgramming cable. When I am uploading/downloading my HMI program to the quickpanel jr. device, in the message column will tell me " device not ready " and eventually will prompt " device hung ". I tried to shutoff the quickpanel jr. power. The message column will prompt " device off ---> turn on power ". When I turn on the power back, I will be prompted again with " device not ready ". I pretty sure that my programming software and cable is fine since I can do the uploading/downloading with another device.
I hope I am asking the right forum and hoping someone out there can help me with my problem.What could be the possible causes and possible solutions ( if there is any )?
Thanks and best regards!