unsaint32
Member
I understand that one of selling features of Controllogix5000 is to be able to swap out a faulty module without powering down the PLC or switching out of RUN mode (obviously to reduce down time).
I did this several times when one of the module's output terminals went bad.
But in the module properties pane of RSLogix 5000, if I checked the "major fault on controller if connection fails in Run Mode," would I still be able to hot-swap the faulty module?
I did this several times when one of the module's output terminals went bad.
But in the module properties pane of RSLogix 5000, if I checked the "major fault on controller if connection fails in Run Mode," would I still be able to hot-swap the faulty module?