Hi, guys, how’s going?
We have one new version Panelview Plus 1500 (2711P-RDT15C) and I tried to access to Configuration Mode to set up its IP address. There are “Reset” and “Default” switches on its back.
After “Reset” switch was pressed, I pressed and hold the white spot on left-down corner as what I did before, but I did not get Configuration Mode.
So I pressed ““Default”, then there were 3 options showing up, e.g. …continue with…; …safe mode…
Could you tell me how to access to Configuration Mode in this new version Panelview Plus 1500?
Thanks a lot.
We have one new version Panelview Plus 1500 (2711P-RDT15C) and I tried to access to Configuration Mode to set up its IP address. There are “Reset” and “Default” switches on its back.
After “Reset” switch was pressed, I pressed and hold the white spot on left-down corner as what I did before, but I did not get Configuration Mode.
So I pressed ““Default”, then there were 3 options showing up, e.g. …continue with…; …safe mode…
Could you tell me how to access to Configuration Mode in this new version Panelview Plus 1500?
Thanks a lot.