How to connect 1200 by libnodave

[PLC_Com]

Hi,I'm a beginner.I want to connect 1200 by libnodave .who can upload a simple example . About how to build communication and Write DB Values .Any language.

Thanks All .

 

[BryanG]

http://www.plctalk.net/qanda/showthread.php?t=95924&highlight=libnodave

http://www.plctalk.net/qanda/showthread.php?t=96941&highlight=libnodave

 

[Mustafa_Aquil]

Hey Bryan,

Did you get anything to sort out the problem with getting the bits above M0.7.

 

[Mustafa_Aquil]

Hey Bryan,

Did you get anything to sort out the problem with getting the bits above M0.7.

I'm using PLC S7-300 using ethernet. Please let me know if to use isotcp or isotcp-200

 

[BryanG]

Hi Mustafa

I haven't spent any time on that project so there are no changes. You could probably look at the projects I listed above and perhaps see the problem, it must either be libnodave or Advanced HMI. You can try libnodave and make sure that it works and then see the link between the two.

I don't have any experience with the 300 range, but I would expect it to be isotcp, the same as with the 1200.

B