Hi, Everyone
I am a beginner to PLC. I am currently working on a project to build a door cycle tester.
Allen Bradley Micrologix 1100 is used to control a Bodine 34B/FV Brushless DC motor. Then this motor drives a shaft system to open/shut the door at certain speed. The final goal is: 1. I am able to set a certain number of cycles then the device will execute it. The values of cycles can be displayed on LCD of AB Mircologix 1100.
My current problem is the motor cannot even be driven by the AB 1100.
This could be an issue of wiring or programming. However, I could not figure it out on my own after lots of tryouts. The code I wrote was just a single rung (closed contact as input, Motor Forward/Reverse as output). Again, it was not working.
I have attached an document here which provides more details of the wiring as well as the programming portion.
I sincerely wish someone could offer me some help. Thanks to all of you.
I am a beginner to PLC. I am currently working on a project to build a door cycle tester.
Allen Bradley Micrologix 1100 is used to control a Bodine 34B/FV Brushless DC motor. Then this motor drives a shaft system to open/shut the door at certain speed. The final goal is: 1. I am able to set a certain number of cycles then the device will execute it. The values of cycles can be displayed on LCD of AB Mircologix 1100.
My current problem is the motor cannot even be driven by the AB 1100.
This could be an issue of wiring or programming. However, I could not figure it out on my own after lots of tryouts. The code I wrote was just a single rung (closed contact as input, Motor Forward/Reverse as output). Again, it was not working.
I have attached an document here which provides more details of the wiring as well as the programming portion.
I sincerely wish someone could offer me some help. Thanks to all of you.