HW diagnostic on HMI

[Tanke]

Hi

I am working on a hardware diagnostic screen for my HMI.
I am using the SFC51 to read the actual status of the profinet nodes.

I would like to make this more generic, as we have predefined nodes for invertes, drive ect.

So I was looking for a way to read what nodes are configured. As this will enable me to create the screen and only show the nodes that are configured for the current system.

Hope you can help me.

 

[adfox]

Look here:

http://support.automation.siemens.com/WW/llisapi.dll?func=cslib.csinfo&objId=5362473&nodeid0=16599820&load=content&lang=en&siteid=cseus&aktprim=0&objaction=csview&extranet=standard&viewreg=WW

and:

http://cache.automation.siemens.com/dnl/DM/DM3NTc3AAAA_5362473_DL/Dp_op_15_e.pdf


and:

http://support.automation.siemens.com/WW/llisapi.dll?func=cslib.csinfo&objId=26996747&objAction=csOpen&nodeid0=16599820&lang=en&siteid=cseus&aktprim=4&extranet=standard&viewreg=WW


Hope it helps

 

[Tanke]

Hi Adfox

I think you have misunderstod me.
I have a working diagnostic system, where I use sfc51 SSL_ID 694 to detect node failures.
What I am looking for is a way to, at startup read what nodes the system expect to be there. This is to make the current system more generic.

But thanks for the links anyways