Hello,
I am working with an ultraware servo and I would like to interact with the motor by sending a digital signal to specify a velocity profile for the motor (this can be done according to the manual)
however I am relatively new to this topic and I'm unsure if how to proceed, is it a case of connecting to the I/O ports and sending a signal (specified voltage) or what? Any help would be great, or a nudge in the right direction would be appreciated.
Thanks
I am working with an ultraware servo and I would like to interact with the motor by sending a digital signal to specify a velocity profile for the motor (this can be done according to the manual)
however I am relatively new to this topic and I'm unsure if how to proceed, is it a case of connecting to the I/O ports and sending a signal (specified voltage) or what? Any help would be great, or a nudge in the right direction would be appreciated.
Thanks