Hi All,
I am having an issue with explicit messaging. I am using a Micrologix 1100 and programing it with rslogix microstarter lite v8.3. The attribute(hex) I am having issues with is 0324H dec:804.
When I enter this attribute I get a "invalid attribute specified" error.
The realworld setup is mirologix1100 connected to a Keyence NU-EP1 ethernet IP module. The sensors connected are two FD-XA2 flow sensors. I have no problem receiving data from the NU-EP1 but the attribute commands are lower value hex.
After struggling for awhile I only get this error if I enter a hex which has a dec value higher than 255.
Keyence says I am set up correctly and Rockwell wont talk to me with out a tech connect account
Help me?
https://photos.app.goo.gl/hJCnFtZkNHjTpXov7
I am having an issue with explicit messaging. I am using a Micrologix 1100 and programing it with rslogix microstarter lite v8.3. The attribute(hex) I am having issues with is 0324H dec:804.
When I enter this attribute I get a "invalid attribute specified" error.
The realworld setup is mirologix1100 connected to a Keyence NU-EP1 ethernet IP module. The sensors connected are two FD-XA2 flow sensors. I have no problem receiving data from the NU-EP1 but the attribute commands are lower value hex.
After struggling for awhile I only get this error if I enter a hex which has a dec value higher than 255.
Keyence says I am set up correctly and Rockwell wont talk to me with out a tech connect account
Help me?
https://photos.app.goo.gl/hJCnFtZkNHjTpXov7