SNK
Member
I am using KepserverEX version 5, and plan to use this OPC Server for data collection/Scada use, but have not been able to make the two software sytsems work together so far.
I have searched the Kepserver site, and the Rockwell site, with no specific answers......(Oh yeah, and this site)
RSEmulate 5K seems to function fine, I can download, monitor etc in Program mode and Run mode flawlessly. I see dynamic data....
The problem arises when I attempt to setup the new device in Kepserver.
This is the process I have gone through in order to setup the communication interface with Kepserver..
I have searched the Kepserver site, and the Rockwell site, with no specific answers......(Oh yeah, and this site)
RSEmulate 5K seems to function fine, I can download, monitor etc in Program mode and Run mode flawlessly. I see dynamic data....
The problem arises when I attempt to setup the new device in Kepserver.
This is the process I have gone through in order to setup the communication interface with Kepserver..
- After selecting a New Device, I add a Contrologix 5500, which seems to be the only logical choice for my application. (there is no Virtual Backplane Emulator listed)
- I enter in my local PC IP address (192.168.1.10,1,2)
- ,1,2(Slot of processor is 2 based on RsEmulate and RSL5K project settings)
- The tags at this point should auto-generate (based on the Kepserver documentation).....but nothing seems to happen.