braxton357
Member
Don't know if anyone has had something like this happen before, but I'm out of ideas...
Micrologix 1400, no i/o being used, only 24v from a rhino power supply and a patch cable from a stride switch, a panelview 800 and a powerflex 525. Everything is great until I power on the VFD breaker then it fries the plc. looks like maybe a triac inside has burned up? No continuity that I can find between any high and low voltage wiring. Any ideas what would cause this?
Micrologix 1400, no i/o being used, only 24v from a rhino power supply and a patch cable from a stride switch, a panelview 800 and a powerflex 525. Everything is great until I power on the VFD breaker then it fries the plc. looks like maybe a triac inside has burned up? No continuity that I can find between any high and low voltage wiring. Any ideas what would cause this?