Hello,
Currently my Kinetic 350 having an error of F43. I checked in the manual as it said:
An attempt was made to enable the axis through
software while the Drive Enable hardware input
was inactive.
Verify that Drive Enable hardware input is active
whenever the drive is enabled through software.
The Drive Enable input that is transitioned from
active to inactive while the axis was enabled.
I tried to find all the hardware input but couldn't find any and only PLC controls the Axis of it. In the PLC, the alarm said Configuration Fault - Feedback1Type - Invalid Attributes Value. Anyone have any suggestions? Thank you.
Currently my Kinetic 350 having an error of F43. I checked in the manual as it said:
An attempt was made to enable the axis through
software while the Drive Enable hardware input
was inactive.
Verify that Drive Enable hardware input is active
whenever the drive is enabled through software.
The Drive Enable input that is transitioned from
active to inactive while the axis was enabled.
I tried to find all the hardware input but couldn't find any and only PLC controls the Axis of it. In the PLC, the alarm said Configuration Fault - Feedback1Type - Invalid Attributes Value. Anyone have any suggestions? Thank you.