Kinetix 300 drive

MartB

Lifetime Supporting Member
MartB
Join Date
Jun 2005
Location
Pinellas Park, FL
Posts
684
Can anyone tell me if the Kinetix 300 has torque limit capability???

(I will now go trawling through manuals, but thought I might get a quick answer here)
 

Similar Topics

O
Kinetix 300 in velocity mode (Servo.Out.ReferenceSource = 1) and drive not run
Hello, I am using Kinetix 300 with CompactLogix (Ethernet IP) and it works well, but happened twice along one day the following situation: I...
Replies
0
Views
1,983
ortega
O
G
Kinetix 300 - How to Command a Motion Without Homing the Drive?
Hey all, Just like the question states, I want to start motion without initiating Home first. How can I do that? Is there a jog command? Thanks,
Replies
5
Views
3,710
gbradley
gbradley
U
Kinetix 300 drive enable signal
I saw a PLC program rung with two outputs in parallel, both for enabling Kinetix 300 drive. One was the structured data bit...
Replies
3
Views
8,836
unsaint32
U
B
Kinetix 5300 MSO causing ExcessiveVelocityErrorFault
Have a system that has been running for over a year and all of a sudden getting a ExcessiveVelocityFault on one of the drives when the MSO command...
Replies
2
Views
150
padees
P
O
Re-Zero a Kinetix 5300/MPAI Electric Cylinder
Hello PLCS.Net Forum, First time posting. Let's assume I am a novice. BASIC PROBLEM: My servo/linear piston is no longer zeroed to the...
Replies
9
Views
225
OhNo
O
Back
Top Bottom