I am missing something. I need the program to run. The only way i can preform this is using the terminal and using an EX 1 command from my laptop. The second program i am trying to use the Su instruction that should run on power up. The motor is a LMDCM571C and software is motion control interface v 5.1.1.0 from the Lexium m drive suite.
Lexium M Drive, Execute Program
- Thread starter sharkyh2o
- Start date
Similar Topics
Hi all,
I'm trying to control a Schneider servo drive, a Lexium ILA2K.
I need to find either the program "SE_Motion_ILx2_ETH_Vxxxx.ACD"
or the...
Hi,
Does anybody have experience setting up communication between Lexium MDrive and Red Lion HMI? I am working on a mini-project to send move...
I have Schneider lexium 32 servo drive connected with BSH1004P21A2A motor. Motor is not running on jog and auto tuning mode at all. Show error...
How can i control the direction Lexium32 Drive and motor with Twido PLC over Modbus?
Should we use 'MC_Start_LXM' or 'ServoStart' FB
to Enable LExium-32A Servo Drive?
we, have used 'MC_Start_LXM' in our program but, without...
