Looking for complete Load Cell / Roller units to lay in conveyor sections

[Baker in Virginia]

Good Afternoon,

I’m limited with a skilled maintenance staff to design and build Load Cell , Rollers , etc. for conveyor sections . Do you folks know of any loadcell manufactures that have complete pre assembled Load Cell / Roller units that can be placed in sections of conveyors ?

Thanks so much ,

 

[Bit_Bucket_07]

Something like this?

https://www.bosche.eu/en/industrial...logistic-and-transport/roller-conveyor-scales

 

[robertmee]

Techweigh. Used them with good success.

https://www.tecweigh.com/products/belt-scales/

 

[Bit_Bucket_07]

Techweigh. Used them with good success.

https://www.tecweigh.com/products/belt-scales/

I've also done a lot of work with Tecweigh, although it has all been with belt conveyors. I'm not sure about whether the OP might have been referring to roller conveyors.

 

[robertmee]

I've also done a lot of work with Tecweigh, although it has all been with belt conveyors. I'm not sure about whether the OP might have been referring to roller conveyors.

Pretty sure the OP is wanting roller sections to place in existing belt conveyors. I could be wrong but "placed in sections of conveyors" was key for me.

 

[Baker in Virginia]

Good Morning. I’m sorry guys . I should have mentioned that . RobertMee is correct . Yes , I have about a 6” wide conveyor . I would like to cut out a section of support underneath, and put a preassembled load cell , with two , maybe 3/4” or 1” diameter rollers on a load cell . Looking to weigh just 15 to 20 lbs .

Thanks so much .

 

[padees]

Browse around https://www.ricelake.com/

They make a lot of different items and may have what you are looking for.

 

[Baker in Virginia]

Thanks so much , Padees . That is exactly what I was looking for . Thanks Everyone.

 

[Jeev]

If you have deep pockets then Mettler Toledo will do everything from Silos and Weighbridges to powder and capsule weighing solutions.

 

[Puddle]

I've used load cells from this company before:

https://www.re-spa.com/en/prodotti/load-cells.aspx

Had to get rollers fabricated though as I needed roughly 2.5m width.

 

[agdacanay77]

Good Day.

https://www.laumas.com/en/product/t...-transmitter-rs485-8-channels-for-load-cells/

Load cell installed in the foot(4) of the conveyor rollers unit.
Hope it will help.
Thanks.

 

[TWS]

we use these: https://www.averyweigh-tronix.com/products/conveyor-scales/weigh-legs-conveyor-scale-system/.