barjim
Guest
B
Well hope somebody out there can help me with this, I was asked to have a VFD Magnatek 703, little old I know, run with tork control with a 0 to 10v reference from my PLC it has an analog speed reference also, the parameter on tork control is SN-19 and is set to 0 on the manual it refers me to change it to 03 to give me a 0 to 200% tork at a 0 to 10v. When I made this change my drive faulted and gave me a GPO alarm, If their is another parameter I should change I would like to know, and where in the manual can I find this.
