Newton W
Member
Hello All,
When trying to go to RUN mode the processor faults and I get this error.
Error description is: Remote Power Failure of an expansion I/O rack occurred.
This is a brand new SLC 5/04 in a 10 slot rack with another 10 slot rack attached.
Power doesn't seem to be an issue with the remote rack. All indicator lights are on that should be (Power supply, Analog In, Analog Out modules).
I suspect the cable, but would like to know if there's something else I could be overlooking. This is part of a skid unit that was checked out at the factory prior to being installed at our facility.
I tried creating a new program and performing a "Read IO Config" and it was able to identify all modules in the main rack, and identify that there was another rack attached, but not able to identify any modules in the remote rack.
Thanks for all your help,
-William
When trying to go to RUN mode the processor faults and I get this error.
Error description is: Remote Power Failure of an expansion I/O rack occurred.
This is a brand new SLC 5/04 in a 10 slot rack with another 10 slot rack attached.
Power doesn't seem to be an issue with the remote rack. All indicator lights are on that should be (Power supply, Analog In, Analog Out modules).
I suspect the cable, but would like to know if there's something else I could be overlooking. This is part of a skid unit that was checked out at the factory prior to being installed at our facility.
I tried creating a new program and performing a "Read IO Config" and it was able to identify all modules in the main rack, and identify that there was another rack attached, but not able to identify any modules in the remote rack.
Thanks for all your help,
-William