Ones_Zeros
Member
Hello
I have two Compact Logic PLC’s that I’m needing to message data from.
I’m having trouble with the communications path portion of the setup.
- I’m needing to read a valve output from a 1769-L32E Compact controller back to a Compact Logix 1769-L30ER controller via Ethernet.
- The PLC that will be doing the Message Read is the 1769-L30ER. I have this setup but keep getting a syntax error. I’m just trying to read over (1) element that’s a DINT.
- The other PLC that I’m reading the data from is a Compact Logix 1769-L32E controller.
I went on Rockwells site and searched their knowledge base on the comms path setup, but I’m not have any success.
Without adding the remote PLC in the IO tree. What would be the correct syntax?
I can’t take the main PLC offline so I need to just enter the comms path.
I appreciate the help
I have two Compact Logic PLC’s that I’m needing to message data from.
I’m having trouble with the communications path portion of the setup.
- I’m needing to read a valve output from a 1769-L32E Compact controller back to a Compact Logix 1769-L30ER controller via Ethernet.
- The PLC that will be doing the Message Read is the 1769-L30ER. I have this setup but keep getting a syntax error. I’m just trying to read over (1) element that’s a DINT.
- The other PLC that I’m reading the data from is a Compact Logix 1769-L32E controller.
I went on Rockwells site and searched their knowledge base on the comms path setup, but I’m not have any success.
Without adding the remote PLC in the IO tree. What would be the correct syntax?
I can’t take the main PLC offline so I need to just enter the comms path.
I appreciate the help
Last edited: