InstrumentationUK
Member
Hello Guys,
I have two different Micro 830 PLCs, namely 2080-LC30-100QWB and other one is 24AWB. I want to make one Micro 830 as Modbus Slave and another Micro830 as Modbus Master and want to pass data from Slave to Master. Both PLCs have 2080-Serial ISOL card for communication.With Connected Components Workbench Software I could setup PLCs as Master and Slave and on Slave PLC I could do the Modbus I/O mapping to send Data over modbus. I cant figure out to receive data in Master. I using Modbus485-RTU network.
Any suggestions please.
Thanks in advance for help.
I have two different Micro 830 PLCs, namely 2080-LC30-100QWB and other one is 24AWB. I want to make one Micro 830 as Modbus Slave and another Micro830 as Modbus Master and want to pass data from Slave to Master. Both PLCs have 2080-Serial ISOL card for communication.With Connected Components Workbench Software I could setup PLCs as Master and Slave and on Slave PLC I could do the Modbus I/O mapping to send Data over modbus. I cant figure out to receive data in Master. I using Modbus485-RTU network.
Any suggestions please.
Thanks in advance for help.