Micro 850 IO Fault
- Thread starter biasotto
- Start date
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/2080-um002_-en-e.pdf
A non-recoverable communication fault has occurred on the expansion I/O module. Because the last number is a 0 the slot number cannot be identified.
See the above manual for Corrective Action for Recoverable and Non-recoverable Faults.
Hope this helps you out.
Regards,
A non-recoverable communication fault has occurred on the expansion I/O module. Because the last number is a 0 the slot number cannot be identified.
See the above manual for Corrective Action for Recoverable and Non-recoverable Faults.
Hope this helps you out.
Regards,
Similar Topics
Hello eveybody. Please help me on this issue.
Micro850 have fault red blinking. I can’t connect to PLC to see fault log. I tried to download...
I am trying to read and write data from Control Logix L23E and a Micro 850.
My path in the message is 2, 192.168.2.183
192.168.2.183 is the ip...
Hello. I have an issue with a Micro 850 PLC. Issue is when it is in RUN mode, and an output is energized, the whole PLC just turns off, then turns...
Hello. I have an issue with a Micro 850 PLC. Issue is when it is in RUN mode, and an output is energized, the whole PLC just turns off, then turns...
I am using a Micro 850E PLC (the new one with implicit messaging capability) to drive a Kinetix 5100 servo drive. The error code number on the...