N_Thompson
Member
Hi all,
I am working on a project where we are using a ML1100 as a modbus master for a large number (10) of identical slaves.
I am currently communicating to 2 with no issues at all with MSG commands.
My Question is, is there a way to 'cycle through' the modbus addresses with the MSG command? Or would I have to address each one seperately?
I would like to write a subroutine where I can write a general program and repeat it for all the slaves in the system. This would create a simpler and smaller program.
Thanks for any help in advance!
I am working on a project where we are using a ML1100 as a modbus master for a large number (10) of identical slaves.
I am currently communicating to 2 with no issues at all with MSG commands.
My Question is, is there a way to 'cycle through' the modbus addresses with the MSG command? Or would I have to address each one seperately?
I would like to write a subroutine where I can write a general program and repeat it for all the slaves in the system. This would create a simpler and smaller program.
Thanks for any help in advance!