mikewood
Member
Hi Guys/Gals
I am having a problem connecting a pressure transducer to an analog module.
This my setup;
Pressure Transducer Thyracont VSC42MA4
4-20ma output Has 9 pin connector using 2 wires
Wiring diagram is like so
Pin 7 o---------------------------o +9-30VDC
Pin 4 o------| Controller |-------o gnd
Analog input 1762-1F4
PLC Micrologix 1200 1762-l40BWA
My question is how do I wire the transducer to the analog input and how do i configure the analog input.
Every time I configure the analog input for 1762-1F4 i get a fault condition.
When i use I/O read configure it give othercard......code=67 and verify program, error shows up as 'other' card detected no current load was taken into account.
I know that is a simple solution to the problem but it has eluded me.
appreciate your help.
I am having a problem connecting a pressure transducer to an analog module.
This my setup;
Pressure Transducer Thyracont VSC42MA4
4-20ma output Has 9 pin connector using 2 wires
Wiring diagram is like so
Pin 7 o---------------------------o +9-30VDC
Pin 4 o------| Controller |-------o gnd
Analog input 1762-1F4
PLC Micrologix 1200 1762-l40BWA
My question is how do I wire the transducer to the analog input and how do i configure the analog input.
Every time I configure the analog input for 1762-1F4 i get a fault condition.
When i use I/O read configure it give othercard......code=67 and verify program, error shows up as 'other' card detected no current load was taken into account.
I know that is a simple solution to the problem but it has eluded me.
appreciate your help.