I have a MicroLogix 1200 that has an 8 input and a 16 output.
Every 6 months-year I get a fault and when online go to error it
is something like it didn't recognize one of the expansion modules.
Clearing error and all is fine. I believe I set something in processor
maybe S:1/8 so cycling power will reset fault. Is that correct?
This controller was reinstalled at a different facility, completely different
program, ran a year and now it gave Fault again.
Is the S:1/8 what needs set in it to clear fault on a cycle of power?
Thanks
Every 6 months-year I get a fault and when online go to error it
is something like it didn't recognize one of the expansion modules.
Clearing error and all is fine. I believe I set something in processor
maybe S:1/8 so cycling power will reset fault. Is that correct?
This controller was reinstalled at a different facility, completely different
program, ran a year and now it gave Fault again.
Is the S:1/8 what needs set in it to clear fault on a cycle of power?
Thanks