e27978
Member
I have a 1762-L24BWA microligix 1200 that gets an input from a proximity switch that is mounted near sprocket the prox picks up once per revolution it is only a 24 tooth #40 chain sprocket the motor is on a vfd that needs to run from 30 to 60hz 50-100 percent
the program reads the input up to about 70 percent is there any way to increse the speed that the input will read I see in the controler manual that there is a input signal delay Selectable: 0.025, 0.075, 0.1,
0.25, 0.5, 1, 2, 4, 8, or 16 ms
I can not find any infromation on selecting a input delay
or is there any other way you know of to reed at such a high speed
if there is no solution in the 1200 are there expansion cards that will read these speeds any help would be appreciated
Thanks
the program reads the input up to about 70 percent is there any way to increse the speed that the input will read I see in the controler manual that there is a input signal delay Selectable: 0.025, 0.075, 0.1,
0.25, 0.5, 1, 2, 4, 8, or 16 ms
I can not find any infromation on selecting a input delay
or is there any other way you know of to reed at such a high speed
if there is no solution in the 1200 are there expansion cards that will read these speeds any help would be appreciated
Thanks