I suggest you start a new thread, you may gey more responses, I do not have FX3G only FX3U with ENET card so could not give it a go, perhaps post a little more on what you have tried, what you are using it for i.e. programming via IDE or OPC etc.
Mitsubishi FX3u-ENET port question
- Thread starter Chris Taylor
- Start date
Similar Topics
Hello,
I have an FX3u-16MR/ES, FX3u-ENET (version 1.0), using GX Works2 Version 1.596W (Trial version).
Using FX Configurator-EN...
I have a FX3u-48M PLC with a FX2n-16EX card, FX3u-4AD and then a FX3u-ENET I am trying to put this processor on our network I have configured the...
For exchange data with 3 PLC FX3U ENET i used FX3U ENET modul and i follow the example from the Mitsuibihi site, with an UDP connection.
In this...
Bonjour,
Je n'ai pas de communication modbus RTU vis la configuration ci-dessus.
J'ai essayé les deux mode ch1 et ch2 mais rien ne fonctionne...
Hello everyone;
I have Mitsubishi PLC FX3U 32M in hydropower plant governor, an error message popped up when a technician was working on an...