KonstantinKolev
Member
Hi,
I have a project with a R04CPU, RD77GF16 and a RJ71PN92 modules. The cell is given to me to change the program since the previous integrator did not managed to get it work as intended.
The programming environment is GXWorks3 and the PLC along with its modules were all green when the cell arrived at the workshop.
When I downloaded my program to the R04CPU and put the PLC in remote run, the error led started blinking.
The error is 0x21A0 which tells that there is a FBFile that is specified in the CPU parameters is not available in the R04CPU.
Well, I checked the CPU Parameters, Program Settings and I can see a FBFile named SlibFBFile that is there but I do not have such a file in the project tree under FB tab. All other FBFiles that I created are there and set in the CPU Parameters.
If I try to delete the SlibFBFile from the CPU Parameters, it appears again after rebuilding the project.
What do you think is the reason for this file to appear?
Best Regards
Konstantin Kolev
I have a project with a R04CPU, RD77GF16 and a RJ71PN92 modules. The cell is given to me to change the program since the previous integrator did not managed to get it work as intended.
The programming environment is GXWorks3 and the PLC along with its modules were all green when the cell arrived at the workshop.
When I downloaded my program to the R04CPU and put the PLC in remote run, the error led started blinking.
The error is 0x21A0 which tells that there is a FBFile that is specified in the CPU parameters is not available in the R04CPU.
Well, I checked the CPU Parameters, Program Settings and I can see a FBFile named SlibFBFile that is there but I do not have such a file in the project tree under FB tab. All other FBFiles that I created are there and set in the CPU Parameters.
If I try to delete the SlibFBFile from the CPU Parameters, it appears again after rebuilding the project.
What do you think is the reason for this file to appear?
Best Regards
Konstantin Kolev