Mas01
Member
Hi, In my ladder logic, I've got a data register D60 whose value is -0.001 (when using monitor mode to see values). D406 is 0.250.
But then later on I have a rung where I m checking if D60 is less than D406 (another FP value).
|---[ < D60 D406 ]------------------(M557)----|
However, in the above, D60 has the value -13332 & D406 has the value 0.
Why are they different? How can I do the < operator when dealing with two FP numbers?
But then later on I have a rung where I m checking if D60 is less than D406 (another FP value).
|---[ < D60 D406 ]------------------(M557)----|
However, in the above, D60 has the value -13332 & D406 has the value 0.
Why are they different? How can I do the < operator when dealing with two FP numbers?
Last edited: