Wtchdctr
Member
:/ I think ive been handed a lemon..
Im in the process of converting my ML1000 Ladder to our new ML1100.
I have all the controller errors out of the old program except 1.
I have 1 rung with my SCL for Signal conditioner input.
Scale Source is I:0.4 (analog input on ML1100, also tried I:0.5)
Destination is set to the same address as it was in the ML1000 matching the data table.
I have a Output module for the analog output (1762-OF4) Modified the ladder for the new output module to my VFD. This rung is fine.
I keep getting the same errors. Ive tried both inputs on the controller and cannot figure this out.
ERROR1: RUNG -1 INS -1:Attempt to set more IO data than has been allocated.
ERROR2: RUNG -1 INS -1:Incorrect output force file size.
Any help would be greatly appreciated. Just ask if more info is needed
Im in the process of converting my ML1000 Ladder to our new ML1100.
I have all the controller errors out of the old program except 1.
I have 1 rung with my SCL for Signal conditioner input.
Scale Source is I:0.4 (analog input on ML1100, also tried I:0.5)
Destination is set to the same address as it was in the ML1000 matching the data table.
I have a Output module for the analog output (1762-OF4) Modified the ladder for the new output module to my VFD. This rung is fine.
I keep getting the same errors. Ive tried both inputs on the controller and cannot figure this out.
ERROR1: RUNG -1 INS -1:Attempt to set more IO data than has been allocated.
ERROR2: RUNG -1 INS -1:Incorrect output force file size.
Any help would be greatly appreciated. Just ask if more info is needed