Drop'ur'Tech
Member
Hello !
I made a modbus plus network between a ¨Panelview plus 1500 and a Modicon CPU 113 03.
My panelview have an Hilscher CIF 50-MBP as communication card. I use Factorytalk view 5.10.00 (my runtime on the panelview is 5.10 too ) and Kepserver 4.5 as an OPC server !
My network is like that :
pv+ 1500/Hilscher card ------modbus plus plug with rs485 cable ------------> modicon CPU 113 03
I set the adress of the modicon in my OPC server as : DM.1.0.0.0.0 and the adress of the card with Sycon software as : node 2 (because the modicon is programming to communicate only with this node).
My problem is : when i run my application on my panelview , i have the error : "device "here is the name of my device in my opc server" is not responding".
So the problem can be the cable but i checked and i'm a hundred per cent sure it work well !
Is there something else i have to configure on my panelview+ like Kepserver port ID or something with rslinx in FTV or i don't know something with serial port etc ?
I didn't find lot of information about modbus plus network and hilscher card so if someone have already done this kind of configuration maybe he could help me
I know my explanation is a little confusing but english isn't my borned langage so sorry , if u want any precision or detail i will answer as fast and as clear as possible !
I made a modbus plus network between a ¨Panelview plus 1500 and a Modicon CPU 113 03.
My panelview have an Hilscher CIF 50-MBP as communication card. I use Factorytalk view 5.10.00 (my runtime on the panelview is 5.10 too ) and Kepserver 4.5 as an OPC server !
My network is like that :
pv+ 1500/Hilscher card ------modbus plus plug with rs485 cable ------------> modicon CPU 113 03
I set the adress of the modicon in my OPC server as : DM.1.0.0.0.0 and the adress of the card with Sycon software as : node 2 (because the modicon is programming to communicate only with this node).
My problem is : when i run my application on my panelview , i have the error : "device "here is the name of my device in my opc server" is not responding".
So the problem can be the cable but i checked and i'm a hundred per cent sure it work well !
Is there something else i have to configure on my panelview+ like Kepserver port ID or something with rslinx in FTV or i don't know something with serial port etc ?
I didn't find lot of information about modbus plus network and hilscher card so if someone have already done this kind of configuration maybe he could help me
I know my explanation is a little confusing but english isn't my borned langage so sorry , if u want any precision or detail i will answer as fast and as clear as possible !