Hi, we have a PLC, CPU 113 03 and we're having
trouble communicating to it via Proworx32.
I'm not sure of any com configurations from
the previous people in this position, we have
basically been left to figure it out on our own.
We are attempting to connect through the Modbus
DB9 connector, is this just straight RS-232 protocol,
and what cabling is required to establish a connection.
We have a MBP USB to serial converter box, as well as
a generic USB to Serial converter at our disposal.
We just can't seem to get anywhere.
Thanks,
T
trouble communicating to it via Proworx32.
I'm not sure of any com configurations from
the previous people in this position, we have
basically been left to figure it out on our own.
We are attempting to connect through the Modbus
DB9 connector, is this just straight RS-232 protocol,
and what cabling is required to establish a connection.
We have a MBP USB to serial converter box, as well as
a generic USB to Serial converter at our disposal.
We just can't seem to get anywhere.
Thanks,
T