scottmurphy
Member
- Join Date
- Oct 2004
- Posts
- 363
I came across a application recently, and noticed the use of a double coil.
My understanding of this is that this will not work, but I am not as familiar with the TSX-Micro as other brands.
In the attached file, the Control Section is before the Alarms section. The Compare %MW100>0 is an image of the attached HMI, so that any of the keys can initiate a fault reset, as well as a low->hi transition of %I1.7. After this rising edge trigger in the 1st rung of the alarms section, is where all the device fault logic is done, and where this reset bit appears.
Will this work?
My understanding of this is that this will not work, but I am not as familiar with the TSX-Micro as other brands.
In the attached file, the Control Section is before the Alarms section. The Compare %MW100>0 is an image of the attached HMI, so that any of the keys can initiate a fault reset, as well as a low->hi transition of %I1.7. After this rising edge trigger in the 1st rung of the alarms section, is where all the device fault logic is done, and where this reset bit appears.
Will this work?