hi all.
I am quite new at Moeller plc, so therefore have some questions.
I have a client with a plc, where I have been sent to the project, but when I try to open it, there comes an error "Could not open Project / library (no valid project / library file."
Does anyone know the cause of this?
I also tried to open project directly on the PLC, but then there's just a error.
"The last online service har ikke er Executed Correctly! Service number: 49 Error number: 80 File 'source.dat' could not be read."
And afterthat
"Source Code could not be read!"
Pc ip: 198168119.1
PLC ip: 198168119200
Martini
I am quite new at Moeller plc, so therefore have some questions.
I have a client with a plc, where I have been sent to the project, but when I try to open it, there comes an error "Could not open Project / library (no valid project / library file."
Does anyone know the cause of this?
I also tried to open project directly on the PLC, but then there's just a error.
"The last online service har ikke er Executed Correctly! Service number: 49 Error number: 80 File 'source.dat' could not be read."
And afterthat
"Source Code could not be read!"
Pc ip: 198168119.1
PLC ip: 198168119200
Martini