Murphy243
Lifetime Supporting Member
Does anyone out there have any experience programming these RTU's with ladder (codesys)?
We have a guy that does our programming in C, but its that hard to get him to make a change to his code, we want to start programming these ourselves. There is no lack of PLC programming experience in our team but we cannot figure out how to interface with the rs232/485 ports (using modbus) from the ladder.
Any advice would be greatly appreciated
We have a guy that does our programming in C, but its that hard to get him to make a change to his code, we want to start programming these ourselves. There is no lack of PLC programming experience in our team but we cannot figure out how to interface with the rs232/485 ports (using modbus) from the ladder.
Any advice would be greatly appreciated