I am trying to message from a SLC 5/05 to a ML 1500 on a network. I need to read from the ML to the SLC 5/05.
Here is my setup.
SLC 5/05- IP address of 192.168.0.110->Unmanaged switch 1-> cabled to Unmanaged switch 2-> 1761-NET-ENI->IP address of 192.168.0.13 ->DF1 RS 232->ML 1500
I have set up the 1761-NET-ENI (D) with the correct IP address and I can successfully navigate through linx to the ML processor so I know that it is not a networking issue. I think it is in my Ethernet to DF1 routing from the ENI to the ML via. DF1 RS 232 cable (1761-CBL-HM02).
I have read to create a RFI data table to monitor the routing, but I was wandering if I could use the message routing tab on my ENI Configuration Utility and how?
Any information on either method would be greatly appreciated.
Ken
Here is my setup.
SLC 5/05- IP address of 192.168.0.110->Unmanaged switch 1-> cabled to Unmanaged switch 2-> 1761-NET-ENI->IP address of 192.168.0.13 ->DF1 RS 232->ML 1500
I have set up the 1761-NET-ENI (D) with the correct IP address and I can successfully navigate through linx to the ML processor so I know that it is not a networking issue. I think it is in my Ethernet to DF1 routing from the ENI to the ML via. DF1 RS 232 cable (1761-CBL-HM02).
I have read to create a RFI data table to monitor the routing, but I was wandering if I could use the message routing tab on my ENI Configuration Utility and how?
Any information on either method would be greatly appreciated.
Ken