Hoosierdaddy
Member
I have an Omron C1000H CPU in fault for "memory error". I first re-seated the memory module (C2000-MR34-V2) and re-loaded the program. I cycled PLC power, and the CPU immediately faulted again with "memory error". I then replaced the memory module with a new one, again loaded the program. Still no change. I then replaced the entire CPU module to no avail.
I'm stumped at this point, and need some advice on where to go from here.
Thanks!
I'm stumped at this point, and need some advice on where to go from here.
Thanks!