Omron CIO 54 Value

[JuanPLC74]

I am modifying this program on a CJ1 Omron PLC.
CIO address 54 is under one MOV command that assigns it a value.

For the rest of the program that value is checked against other values with =(300)

However this address takes the value then start swinging between the assigned value and 0.

nothing else on the program is assigning a value to 54.

Is there a way to know where this assignment of 0 is coming from?

 

[JuanPLC74]

I am modifying this program on a CJ1 Omron PLC.
CIO address 54 is under one MOV command that assigns it a value.

For the rest of the program that value is checked against other values with =(300)

However this address takes the value then start swinging between the assigned value and 0.

nothing else on the program is assigning a value to 54.

Is there a way to know where this assignment of 0 is coming from?

it is probably attached to a devicenet node, anybody knows how to take the node out of configuration