ndzied1
Lifetime Supporting Member
The DAQ uses an i430 Analog input which looks like it has 100MΩ input impedance.
One 4-20mA analog signal to two PLC inputs possible?
- Thread starter spaceacealpha
- Start date
Similar Topics
Just asking for clarification here, but from my research all I need is a 500 ohm resistor across the AI and the common? Heres my schematic.
I...
I need some help.
I have a 1769-IF4 analog card that is hooked up to strain gages, the gages give a 4-20ma signal to the card.
We had an...
I am a new plc programmer and I have the task of programing unity pro s, I am using a modicon m340 analog module, I have a laser sensor which...
Hi,
I need to read three 4-20mA signals from a DCS(ABB) in a remote 6 channel analog input module with RS485 modbus port.
When I connected...
Gents
I'm working on a small project here and the customer requested to control the drive with 4-20mA by using Micro820 Analog output 4-20mA...