Hi,
we are using Rx3i CRU320 redundant PLC system and we noticed a discrepancy between Primary and Secondary controller.
Couple of variables (DI) which are "high" on the Secondary controller are "low" on the Primary.
I don't have much experience with GE/Emerson Rx3i system and I am not quite sure where to start
It looks to be a problem with transfer between Secondary and Primary PLC.
Any suggestions are highly appreciated.
Thank you.
we are using Rx3i CRU320 redundant PLC system and we noticed a discrepancy between Primary and Secondary controller.
Couple of variables (DI) which are "high" on the Secondary controller are "low" on the Primary.
I don't have much experience with GE/Emerson Rx3i system and I am not quite sure where to start
It looks to be a problem with transfer between Secondary and Primary PLC.
Any suggestions are highly appreciated.
Thank you.