BrendanDixon
Member
Hi All,
We have just purchased a lathe from Rafamet in Poland. The machine has just been installed and I noticed the machine does not have any labeling on the wires.
All the components are labelled and the terminal points at the bottom of the panel have numbers.
The Drawings show the wire going to each device and terminal number. But if someone had to change a wire it would almost be impossible to find.
The machine has the CE mark on it.
What I would like to know is if there are any regulations that require the wires to have labeling on them.
We have just purchased a lathe from Rafamet in Poland. The machine has just been installed and I noticed the machine does not have any labeling on the wires.
All the components are labelled and the terminal points at the bottom of the panel have numbers.
The Drawings show the wire going to each device and terminal number. But if someone had to change a wire it would almost be impossible to find.
The machine has the CE mark on it.
What I would like to know is if there are any regulations that require the wires to have labeling on them.