KerryP
Member
I installed a new PanelView Plus to replace a PanelView Classic and converted the program. That process went pretty well. The PV Plus has been on line about ten days. Last night I got a call that the screen went white and the maintenance person had to reset it to get it to work normally again. I searched online and read posts going back to like 2004. Some of the older posts seemed to point toward hardware issues while some of the new posts spoke of the PanelView navigating to non-existant screens.
This application does not use PLC-based screen control. However, during development I deleted the [ALARM], [INFORMATION] and [DIAGNOSTICS] displays just to see what would happen if I built my own instead. At my age, I should know better.
I will now search for how to restore these screens to this application because I am haunted by guilt about my indiscretions.
Otherwise, I am looking for suggestions.
This application does not use PLC-based screen control. However, during development I deleted the [ALARM], [INFORMATION] and [DIAGNOSTICS] displays just to see what would happen if I built my own instead. At my age, I should know better.
I will now search for how to restore these screens to this application because I am haunted by guilt about my indiscretions.
Otherwise, I am looking for suggestions.