Spotless
Member
Dear Team,
I need experts advice on how to resolve the problem below :
We have two 1756-L55 RSLogix5000 Controllers installed in a redundancy configuration each with one 1756-ENBT Module.
Problem :
Everything looks good until attempt to synchronize, then the controller goes into minor fault with solid red and the fault log below.
(Type 04) Program Fault
(Code 07) GSV/SSV destination tag too small to hold all data.
I have checked configuration of all the GSV instructions and every looks good.
The primary controller can work without coming up with this fault.
The same fault was reported even when the active controller was made the secondary. This suggests the problem is not controller specific but synchronization problem.
I need experts advice on how to resolve the problem below :
We have two 1756-L55 RSLogix5000 Controllers installed in a redundancy configuration each with one 1756-ENBT Module.
Problem :
Everything looks good until attempt to synchronize, then the controller goes into minor fault with solid red and the fault log below.
(Type 04) Program Fault
(Code 07) GSV/SSV destination tag too small to hold all data.
I have checked configuration of all the GSV instructions and every looks good.
The primary controller can work without coming up with this fault.
The same fault was reported even when the active controller was made the secondary. This suggests the problem is not controller specific but synchronization problem.