Hi everyone,
I have this installation I need to figure out but I have a problem.
Some %MW's are only used as 'Read' in the PL7 program. So in the PL7 program there is nowhere a 'Write' of the %MW's. My guess is that those variables come from the operation Terminal XBT-P022110. Where you can adjust the time, temperature setpoints,...
My question is how can I know this for sure? Is there software for the XBT-P022110? Where you can monitor the variables? Or anything else?
grtz,
rubenvp
I have this installation I need to figure out but I have a problem.
Some %MW's are only used as 'Read' in the PL7 program. So in the PL7 program there is nowhere a 'Write' of the %MW's. My guess is that those variables come from the operation Terminal XBT-P022110. Where you can adjust the time, temperature setpoints,...
My question is how can I know this for sure? Is there software for the XBT-P022110? Where you can monitor the variables? Or anything else?
grtz,
rubenvp