sparkytex
Lifetime Supporting Member
Hello every one. Here's what im trying to do. I need to use 6 Message instructions to send values from one ethernet processor to another, both PLC 5/40E processors. I have 4 inputs to binary to send, one output to binary, and one binary to binary. Here are the Local and target (dest.) address's;
Local I:025/14 (e-stop) node 180d dest. b3:3/1 node 50d
Local I:025/15 (CL2 sensor 1)node 180d Dest. b3:3/2 node 50d
Local I:025/16 (CL2 sensor 2)node 180d Dest. b3:3/3 node 50d
Local I:025/17 (CL2 sensor 3)node 180d Dest. b3:3/4 node 50d
Local O:013/16 (CL2 SSV) node 180d Dest. b3:3/5 node 50d
Local B3:3/6 (HMI stop) node 50d Dest. b3:0/5 node 180d
I tried to make it happen but im not exactly sure how to set it up. Is it even possible to send an input address into a binary address through a MSG instruction. I need the values from the 180d processor "sludge" onto the 50d processor "BPMCC1" so i can put the CL2 sensors, e-stop, and SSV as feedback icons onto my wonderware HMI program. The wonderware cannot talk to the sluge PLC directly. The WW is however set up to talk to the BPMCC1. They are all reads except the B3:3/6 which is an "e-stop" from the WW HMI to the sludge PLC as a write. Please let me know if this is possible and or how to set this up in the MSG instruction setup screen.
thanks!!
Local I:025/14 (e-stop) node 180d dest. b3:3/1 node 50d
Local I:025/15 (CL2 sensor 1)node 180d Dest. b3:3/2 node 50d
Local I:025/16 (CL2 sensor 2)node 180d Dest. b3:3/3 node 50d
Local I:025/17 (CL2 sensor 3)node 180d Dest. b3:3/4 node 50d
Local O:013/16 (CL2 SSV) node 180d Dest. b3:3/5 node 50d
Local B3:3/6 (HMI stop) node 50d Dest. b3:0/5 node 180d
I tried to make it happen but im not exactly sure how to set it up. Is it even possible to send an input address into a binary address through a MSG instruction. I need the values from the 180d processor "sludge" onto the 50d processor "BPMCC1" so i can put the CL2 sensors, e-stop, and SSV as feedback icons onto my wonderware HMI program. The wonderware cannot talk to the sluge PLC directly. The WW is however set up to talk to the BPMCC1. They are all reads except the B3:3/6 which is an "e-stop" from the WW HMI to the sludge PLC as a write. Please let me know if this is possible and or how to set this up in the MSG instruction setup screen.
thanks!!